3M 5952 VHB Die-Cut Foam Tape Pads, 62mm x 38mm with Pull Tabs (for GoPro & Dash Cams)

3M™ 5952 VHB™ Heavy Duty Die-Cut Foam Tape Mounting Pads (62mm x 38mm / approx. 2.44" x 1.5", 1.1mm Thick) with Easy-Peel Extended Pull Tabs provide extreme structural holding power for action cameras, vehicle electronics, and exterior automotive accessories. Precision die-cut to match the standard footprint of GoPro flat and curved base mounts, each pad features an extended red release liner tab for rapid, frustration-free peeling without picking at corners or touching the adhesive.

Key Features

• Exact GoPro Base Dimensions: Precision die-cut to 62mm x 38mm with rounded corners to fit GoPro Hero, DJI Osmo Action, and Insta360 adhesive base brackets seamlessly.
• Convenient Easy-Peel Pull Tabs: Designed with extended release liner tabs for quick, clean peeling even when wearing gloves or on fast assembly jobs.
• Genuine 3M 5952 Modified Acrylic Chemistry: Delivers extreme shear and tensile strength, permanently replacing mechanical screws, bolts, and suction cups on high-vibration equipment.
• 1.1mm (45 mil) Viscoelastic Foam Core: Absorbs mechanical shock, dampens motorcycle/vehicle road vibration, and accommodates mismatched surface contours.
• Waterproof & Weatherproof Seal: 100% closed-cell acrylic foam creates an impenetrable barrier against water, mud, saltwater, UV rays, and extreme outdoor weather.
• Multi-Substrate Adhesion: Bonds tenaciously to smooth plastics (ABS, polycarbonate), powder-coated metals, glass, aluminum, and painted motorcycle helmets.

Technical Specifications

Recommended Applications

• Action Camera Mounting: GoPro Hero, DJI Action, and Insta360 flat/curved mounts on motorcycle helmets, surfboards, car hoods, and roll bars.
• Automotive Electronics: DVR dashcam brackets, radar detectors, toll pass transponders, GPS receivers, and interior display screens.
• Fleet & Commercial Equipment: Telematics sensors, barcode scanner cradles, warehouse terminal mounts, and cab electronics.

Application Instructions

1. Surfaces must be thoroughly degreased and cleaned with a 50:50 mixture of isopropyl alcohol (IPA) and water, then dried completely.
2. Apply the pad firmly to the camera mount base, applying firm pressure (minimum 15 psi) across the entire surface.
3. Grasp the extended pull tab and peel off the red release liner effortlessly.
4. Align the mount onto the target surface (helmet, windscreen, or body panel) and apply firm pressure for 30 seconds.
5. Allow adhesive to wet out: ~50% bond strength reached after 20 minutes, ~90% after 24 hours, and 100% full structural strength achieved after 72 hours before heavy sports use.